![]() ![]() Their whole raison de vivre is to get the gunk and pollution out of your fish tank. Keeping your Aquarium Filter CleanĪquarium filters don’t really stay clean as a rule. Still not working? Check the owner’s manual or call the manufacturer. *As a final step, make sure it is functioning properly. Follow steps one, two and four from above. If you do need to clean it, just give it a quick once over with water from the tank. Since you want your biological filter to be filled with lots of delicious and tank skimming bacteria, you don’t want to clean it much. Remove the carbon before you start step one and replace it with the new carbon when you’re done, right before reattaching the filter to the tank. Just follow steps one, two and four from above. If you have a chemical filter on your tank, the only cleaning it really needs is for you to swap out the carbon on a regular basis, say once a week or whenever the water seems cloudy, whichever comes first. ![]() ![]() Pour any remaining water from your cleaning project inside it, if it isn’t crawling with gunk, that is, and turn the filter back on. Now return the sponge or pad to the filter and return the filter to your fish tank. You can scrub any hard to reach spots by using a filter cleaning brush, which you can find at most pet supply stores. Use the leftover water in the bowl to clean the other parts of the filter, or grab a little more from the tank if the water in the bowl is too dirty. But do not do this unless you feel it’s absolutely necessary. *If your sponge or pad is horribly dirty, feel free to replace it. If touching aquarium water is too icky for you, either wear gloves or recruit a friend to do it for you. Squeezing the sponge to get out the gunk will not remove all of the beneficial bacteria that is on the sponge, which is what is protecting your fish from ammonia in the water, so feel free to wash the sponge until the water moving through it runs clear. Simply wash all of the gunk off of the sponge with the water and your hands. Since you’ve already got your bowl of water assembled, this step should be relatively quick and painless, which is good, since you don’t want your fish to be filter-less for long. To save your floor, you will want to have an awaiting bowl, bucket or sink. Then take it off of your tank if you can. Unplug your mechanical filter to avoid shocking yourself as you clean it. Drain it into a medium sized bowl, like a small mixing bowl, or drain it in a bucket and transfer it to the bowl. Use your siphon, plastic cup, etc., to remove as much water as you think you’ll need. Sure the filter may not smell as clean and fresh, but your fish will be less sensitive to the change. For the benefit of your fish, you will want to use existing tank water, not tap water or distilled water. You will need about two cups of water from the tank to use to clean the filter’s sponge. This is the main component of the filter that you will need to clean. If you have a mechanical filter, you will most likely have a sponge or pad that sits inside it. Then look up your filter type below and get started. ![]() This should be fairly obvious to you just by looking at your filter, but be sure to consult the owner’s manual to make sure there are no specific directions on cleaning for your particular model. The second thing to remember about cleaning your aquarium filter is that the cleaning method you should use depends on the type (or types) of filter that you have. That way your fish will have had time to adjust to his new environment before another shock to his system happens with the disruption of his water and routine. When should you clean your aquarium’s filter? Well, when it is dirty of course, but you should wait at least a week from the last time you cleaned the fish tank. Filters help clean and purify the water in your fish tank, but unfortunately, the filter cannot properly do its job if it’s clogged with filth. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |